Knowledge
Cat litter particle size: what to pin down in a specification
Particle size is one line of a cat litter specification. This note lists the items a buyer and a factory should agree on before a batch is produced.
Start from the sieve, not the number
A particle size stated as a single number is not a specification. What a buyer usually wants to control is a distribution: how much of the product sits in each band, how much is dust below the smallest useful grain, and how much is oversize that reads as coarse or scratchy to the cat.
Two factories can both claim the same headline range and still ship different products, because the bandwidth, the test sieve set and the sampling method are not the same.
- Sieve set and mesh apertures used for the check
- Passing rate in each band, not just the headline range
- Dust fraction below the smallest band
- Oversize fraction above the largest band
The items worth writing into the specification
A short clause list removes most of the argument later. The list below is the one we work to when a buyer brings a target product.
- Base material or blend, and the raw-material grade
- Particle size bands with an allowed passing rate for each
- Bulk density, stated together with the test method
- Clumping strength and the test conditions used to measure it
- Absorption capacity per unit mass, with the method
- Moisture content and the drying route
- Dust level and the screening method behind it
- Colour and any added function, such as odour control
- Bag format and the net weight or volume per pack
How the numbers are measured matters as much as the numbers
A test result is only comparable when the method is the same. Clumping strength, for example, can be reported as the force needed to break a formed clump or as the residue left after a set time in water; those are two different measurements. When a specification does not name the method, the factory will use its own, and the buyer cannot tell whether a later batch really matches.
What to confirm before the first batch
Send a target sample or an existing product, and ask the factory to report the measured values on that reference. Agree the sampling point, the frequency of the check, and which values are declared on the certificate of analysis.
Where a buyer needs product documentation, we provide what we hold on request rather than quoting certificates that may not apply to the order.
Where this fits in a private label project
For a private label order the specification is the shared document between the buyer's brand and the production line. Our OEM track starts from the same clause list, then fixes the packaging and the label. The product pages below show how a base material is carried through to a packed bag.
Talk to us about your OEM / ODM project
Send your target market, pack size and expected volume, and we will come back with a quotation.
